Wall/Hanging Drill w/Gardner-Denver RMH Feed & PR123J Drifter

Wall Drill/Hanging Drill w/Gardner-Denver RMH Feed & PR123J Drifter

Check out the bottom of the page to view more pictures!

Model RHM Chain Feed Mounting

    Model "RMH" Series is powered by the Gardner-Denver Model MA3RMR (5 Cylinder - 3 Horse Power) Feed Motor, mounted in a fixed position.  The drive chain is roller & link design with - 1" pitch.  (Type 80H).  The mast is a strong construction using 9 lb. per ft. - 5" channel.  The outside dimensions of the mast have not been changed, but the change to a heavier channel requires a new mounting slide.  The throttle valve is the "Bank-Spool" design and conveniently operates all phases of drill-blow-rotatoin and feed from the one bank of controls and which can be located at any convenient location on the mast or entirely detached and remounted at another location for "remote" operation for operators convenience.


    A Gardner-Denver Liner Oiler, recommended by the factory, must be used in all cases and is supplied with each Chain Feed, except when the Chain Feed is Mounted on a Rig or Air Trac etc., then the Line Oiler is supplied as part of the Rig the Chain Feed is mounted on.  It is therefore necessary that informatoin be given regarding the "Mounting" when Chain Feeds are ordered.  Grease Fittings are assembled on all Chain Feeds at all points requiring lubrication.